“Graphics and specifications may change without notice”.ASSEMBLY MANUALMS: 164Specifications:Wing span -----------------------------65in (165cm).Wing
CASSUTT 3M RACER. Instruction Manual10 1) Locate the items neccessary to install
www.seagullmodels.com11C/A glue.Landing Gear.wheel Pant.Locker glue. 7) Tighten the setcrews using a hexwrench to secure the collars on the axle ov
CASSUTT 3M RACER. Instruction Manual12COWLING INSTALLATION. 1) Slide the fiberglas
www.seagullmodels.com13The propeller should not touch any partof the spinner cone. If it does, use asharp modeling knife and carefully trim awaythe s
CASSUTT 3M RACER. Instruction Manual144) Apply 2-3 drops of thin C/A to each of th
www.seagullmodels.com159) Set the aileron hatch in place and use aPhillips screw driver to install it with four woodscrews.Wing.M2 lock nut.Aileron.M
CASSUTT 3M RACER. Instruction Manual16Remove covering.INSTALLING THE HORIZONTALSTAB
www.seagullmodels.com17 7) When you are sure that everything isaligned correctly, mix up a generous amountof 30 Minute Epoxy. Apply a thin layer to
CASSUTT 3M RACER. Instruction Manual18RUDDER AND ELEVATOR PUSHRODHORN INSTALLATIO
www.seagullmodels.com19MOUNTING THE TALI WHEEL.Required Parts• Fuselage assembly• Tail wheel assembly• M3 Washer(2)• M3x30mm socket head screw(2)• M3x
CASSUTT 3M RACER. Instruction Manual2INTRODUCTION. Thank you for choosing the
CASSUTT 3M RACER. Instruction Manual20- Apply a bead of canopy glue around the insi
www.seagullmodels.com21INSTALLING THE BATTERY-RECEIVER. 3) Route the antenna in the antenna tubeinside the fuselage and secure it to the bot-
CASSUTT 3M RACER. Instruction Manual22Ailerons:High Rate :Up : 20 mmDown : 20
www.seagullmodels.com23 3) Double check the balance of the air-plane. Do this with the fuel tank empty. 4) Check the control surfaces. All sh
www.seagullmodels.com3ADDITIONAL ITEMS REQUIRED. 1.2-1.8 cu.in 2-4-stroke 20cc-26cc Radio 4 channels with 6 digitalservos. Glow plug to suit
CASSUTT 3M RACER. Instruction Manual4 INSTALL RUDDER CONTROL HORN.Required Parts• T
www.seagullmodels.com5Thread locker glue. 3) Carefully bend the second nylon tubeup at a 45º angle. This tube is the vent tube. 1) Using a modeling
CASSUTT 3M RACER. Instruction Manual6Blow through one of the lines to ensurethe fue
www.seagullmodels.com7INSTALLING THE FUSELAGE SERVO. 1) Install the rubber grommets and brasscollets onto the throttle servo. Test fit the servointo
CASSUTT 3M RACER. Instruction Manual8Elevator servo arm.Install the switch into the
www.seagullmodels.com94mm diameter.4) On the fire wall has the location for thethrottle pusshrod tube (pre-drill).Machine Screw M4x30mm.Pushrod wire.
Comments to this Manuals