Seagull Mini MXS-R EP Specifications download pdf (Page 16)

MINI MXS-R EP Instruction Manual.

16

 5) Slide the vertical stabilizer back in

place. Using a triangle, check to ensure that

the vertical stabilizer is aligned 90º to the hori-

zontal stabilizer.

90º

Vertical

Stabilizer.

Horizontal

Stabilizer.

 6) When you are sure that everything is

aligned correctly, mix up a generous amount of

Flash 30 Minute Epoxy. Apply a thin layer to the

mounting slot in the top of the fuselage and to

the sides and bottom of the vertical stabilizer

mounting area. Apply epoxy to the bottom and

top edges of the filler block and to the lower

hinge also. Set the stabilizer in place and re-

align. Double check all of your measurements

once more before the epoxy cures. Hold the

stabilizer in place with T-pins or masking tape

and remove any excess epoxy using a paper

towel and rubbing alcohol. Allow the epoxy to

fully cure before proceeding.

ELEVATOR - RUDDER PUSHROD HORN

INSTALLATION.

 1) Install the elevator control horn using

the same method as with the aileron control

horns.

 2) Position the elevator control horn on

the both side of elevator.

C/A glue.

Hinge.

When cutting through the covering to re-

move it, cut with only enough pressure to

only cut through the covering itself. Cutting

into the balsa structure may weaken it.

Pen.

Cut.

 4) Remove the stabilizer. Using a mod-

eling knife, remove the covering from below

the lines you drew.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments